Sony XDCA-FX9 Extension Unit for PXW-FX9 Camera - Manual (Page 57)

57
• IP Address
Input the IP address of the camcorder. This
setting is available only when DHCP is set
to Off.
• Subnet Mask
Input the subnet mask of the camcorder.
This setting is available only when DHCP
is set to Off.
• Gateway
Input the default gateway for the access
point.
This setting is available only when DHCP
is set to Off.
• DNS Auto
Set to acquire DNS automatically.
When set to On, the DNS server address is
automatically acquired. This setting is
available only when DHCP is set to On.
• Primary DNS Server
Input the primary DNS server for the
access point.
This setting is available only when DNS
Auto is set to Off.
• Secondary DNS Server
Input the secondary DNS server for the
access point.
This setting is available only when DNS
Auto is set to Off.
6
When finished, select Connect to
connect to the access point.
Connecting manually
1
Perform steps 1 to 3 in “Connecting to
an access point using WPS” (page 56) .
2
Select ST Mode Settings >Manual
Register
(page 114) >Execute in the
Network menu.
Momentarily, the network (access point)
details screen appears.
3
Configure the following connection
settings.
• SSID
Input the SSID for the connection access
point.
• Security
Select the encryption method.
• Password
Input the password for the connection
access point.
• DHCP
Set the DHCP setting.
When you set to On, the IP address is
assigned to the camcorder automatically.
To assign the IP address to the camcorder
manually, set to Off.
• IP Address
Input the IP address of the camcorder. This
setting is available only when DHCP is set
to Off.
• Subnet Mask
Input the subnet mask of the camcorder.
This setting is available only when DHCP
is set to Off.
• Gateway
Enter the address of the gateway.
This setting is available only when DHCP
is set to Off.
• DNS Auto
Set to acquire DNS automatically.
When set to On, the DNS server address is
automatically acquired. This setting is
available only when DHCP is set to On.
• Primary DNS Server
Input the address of the primary DNS
server.
This setting is available only when DNS
Auto is set to Off.
• Secondary DNS Server
Input the address of the secondary DNS
server.
This setting is available only when DNS
Auto is set to Off.
4
When finished, select Connect to
connect to the access point.
You can connect with a device by connecting the
wired LAN connector of the camcorder to a LAN
switch using a LAN cable.
Connecting to a device using a
LAN cable