ProSoft Technology 5201-MNET-101S - Manual (Page 48)

101S Protocol Configuration IEC-101 Slave ♦ ProLinx Communication Gateway
Protocol Manual IEC 60870-5-101 v3 Slave (Firmware version 3.xx)
Page 48 of 159 ProSoft Technology, Inc.
August 6, 2010
2.15 [C_SE_NA_1]
This section defines the normalized setpoint database. This information is
sourced from the remote Master and is transferred to the database.
You can associate a command with a monitored single-point database value to
coordinate the command/monitor operation. You must enter the correct M ONITOR
P OINT # and M ONITOR DB ADDRESS values in the table. If the R EQUIRE S ELECT
parameter is not set to zero, a select command must be received before an
execute command will be processed.
This section takes the following parameters:

P OINT #
 DB ADDRESS
 M ONITOR P OINT #
 M ONITOR DB ADDRESS
 R EQUIRE S ELECT
Each point consumes one word. The DB A
DDRESS value corresponds to the word
offset in the database.
The
DB ADDRESS should be located in a database area that is being constantly
moved from the Master to the gateway.
For additional information on how to set these parameters, see the Reference
chapter of this manual.
2.16 [C_SE_NB_1]
This section defines the scaled setpoint database. This information is sourced
from the remote Master and is transferred to the database.
You can associate a command with a monitored single-point database value to
coordinate the command/monitor operation. You must enter the correct M ONITOR
P
OINT
# and M
ONITOR
DB
ADDRESS values in the table. If the R
EQUIRE
S
ELECT
parameter is not set to zero, a select command must be received before an
execute command will be processed.
This section takes the following parameters:

P OINT #
 DB
ADDRESS
 M ONITOR P OINT #
 M ONITOR DB ADDRESS
 R
EQUIRE
S
ELECT
Each point consumes one word. The DB A DDRESS value corresponds to the word
offset in the database.
The
DB ADDRESS should be located in a database area that is being constantly
moved from the Master to the gateway.
For additional information on how to set these parameters, see the Reference
chapter of this manual.