ProSoft Technology 5201-MNET-101S - Manual (Page 133)

IEC-101 Slave ♦ ProLinx Communication Gateway IEC 60870-5-101 Slave Interoperability Statement
IEC 60870-5-101 v3 Slave (Firmware version 3.xx) Protocol Manual
ProSoft Technology, Inc. Page 133 of 159
August 6, 2010
 <34> := Measured value, normalized value with time tag
CP56Time2a M_ME_TD_1
 <35> := Measured value, scaled value with time tag
CP56Time2a M_ME_TE_1
 <36> := Measured value, short floating-point value
with time tag CP56Time2a M_ME_TF_1
 <37> := Integrated totals with time tag CP56Time2a M_IT_TB_1
 <38> := Event of protection equipment with time tag
CP56Time2a M_EP_TD_1
 <39> := Packed start events of protection equipment
with time tag CP56time2a M_EP_TE_1
 <40> := Packed output circuit information of protection
equipment with time tag CP56Time2a M_EP_TF_1
6.6.2 Process Information in Control Direction
(Station-specific parameter; mark each Type ID " X" if it is only used in the
standard direction, " R" if only used in the reverse direction, and "B" if used in
both directions)

<45> := Single command C_SC_NA_1
 <46> := Double command C_DC_NA_1
 <47> := Regulating step command C_RC_NA_1
 <48> := Set point command, normalized value C_SE_NA_1
 <49> := Set point command, scaled value C_SE_NB_1
 <50> := Set point command, short floating-point value C_SE_NC_1
 <51> := Bitstring of 32 bit C_BO_NA_1
 <58> := Single command with time tag CP56Time2a C_SC_TA_1
 <59> := Double command with time tag CP56Time2a C_DC_TA_1
 <60> := Regulating step command with time tag
CP56Time2a C_RC_TA_1
 <61> := Set point command, normalized value
with time tag CP56Time2a C_SE_TA_1
 <62> := Set point command, scaled value
with time tag CP56Time2a C_SE_TB_1
 <63> := Set point command, short floating-point value
with time tag CP56Time2a C_SE_TC_1
 <64> := Bitstring of 32 bits with time tag CP56Time2a C_BO_TA_1
Either the ASDUs of the set <45>-<51> or of the set <58>-<64> are used.