ProSoft Technology 5201-MNET-101S - Manual (Page 128)

Reference IEC-101 Slave ♦ ProLinx Communication Gateway
Protocol Manual IEC 60870-5-101 v3 Slave (Firmware version 3.xx)
Page 128 of 159 ProSoft Technology, Inc.
August 6, 2010
5.2.8 Slave Error and Status
The 101S Driver Error and Status Data areas are discussed in this section. This
data represents a collection of status, diagnostic and troubleshooting registers
which may prove helpful in troubleshooting the 101S network and port operation.
The data map functionality of the gateway must be utilized in order to map this
data into the normal gateway database region (0 to 3999). All or any portion of
the data can be moved using this facility.
The data area is filled with zeros whenever the gateway is initialized. This occurs
during a cold-start (power-on), reset (reset push-button pressed) or a warm-boot
operation (from a warm command or after loading of new configuration).
IEC870-5-101 Slave Driver Error/Status Data
Offset Parameter Description
10100 Bad Checksum
Count
This word contains the total number of frames received by the
gateway that contain a bad check-sum values in the message.
10101 Sync Error Count This word contains the total number of frames received by the
gateway that have synchronization errors. Each frame in the
protocol has a specific header that must be received in a fixed
sequence. If this header is not received correctly, this word will
be incremented, and the frame will be discarded.
10102 Frame Length
Error Count
This word contains the total number of frames received by the
gateway that do not have the correct length.
10103 Timeout Error
Count
This word contains the total number of frames received by the
gateway that were not received within the specified receive
timeout parameter.
10104 Receive Frame
Count
This word contains the total number of frames received by the
gateway.
10105 Transmit Frame
Count
This word contains the total number of frames transmitted by the
gateway.
10106 to
10199
No valid data Reserved.