Parameter loading, Parameter activation, Test procedure – ProSoft Technology 5201-MNET-101S User Manual
Page 140: File transfer
IEC 60870-5-101 Slave Interoperability Statement
IEC-101 Slave ♦ ProLinx Communication Gateway
Protocol Manual
IEC 60870-5-101 v3 Slave (Firmware version 3.xx)
Page 140 of 159
ProSoft Technology, Inc.
August 6, 2010
6.8.10 Parameter Loading
(Object-specific parameter; mark "
X" if function is only used in the standard
direction, "
R" if only used in the reverse direction, and "B" if used in both
directions)
Threshold value
Smoothing factor
Low limit for transmission of measured value
High limit for transmission of measured value
6.8.11 Parameter Activation
(Object-specific parameter; mark "
X" if function is only used in the standard
direction, "
R" if only used in the reverse direction, and "B" if used in both
directions)
Act/deact of persistent cyclic or periodic transmission of the addressed
object
6.8.12 Test Procedure
(Station-specific parameter; mark "
X" if function is only used in the standard
direction, "
R" if only used in the reverse direction, and "B" if used in both
directions)
Test procedure
6.8.13 File Transfer
(Station-specific parameter; mark "
X" if function is used)
File transfer in monitor direction
Transparent file
Transmission of disturbance data of protection equipment
Transmission of sequence of events
Transmission of sequence of recorded analogue values
File transfer in control direction
Transparent file