ProSoft Technology MVI56E-MNET/MNETXT - Manual (Page 88)

Diagnostics and Troubleshooting MVI56E-MNET / MNETXT ♦ ControlLogix Platform
User Manual Modbus TCP/IP Interface Module
Page 88 of 181 ProSoft Technology, Inc.
April 23, 2014
4.1 LED Status Indicators
4.1.1 Scrolling LED Status Indicators
The scrolling LED display indicates the module's operating status as follows:
Initialization Messages
Code Message
Boot / DDOK Module is initializing
Ladd Module is waiting for required module configuration data from
ladder logic to configure the application port(s)
Waiting for Processor Connection Module did not connect to processor during initialization
 Sample ladder logic or AOI is not loaded on processor
 Module is located in a different slot than the one
configured in the ladder logic/AOI
 Processor is not in RUN or REM RUN mode
Last config: Indicates the last date when the module changed its IP
address. You can update the module date and time through the
module’s web page, or with the optional MVI56E Advanced
Add-On Instruction.
C0 (Client): CmdCnt: X MinDly :
X CmdOffs: X RespTmout : X
Retries : X ErrOffs : X
ARPTmout : X ErrDelay : X
FltFlag : X FltSt : X FltOffs : X
SVR (server) : BIOffs: X WIOffs :
X OutOffs : X HoldOffs : X
FltFlag : X FltSt : X FltSt : X
CommTmout : X After power up and every reconfiguration, the module will
display the configuration of the application port(s). The
information consists of:
Client

CmdCnt : number of commands configured for the Client
 MinDly : Minimum Command Delay parameter
 CmdOffs : Command Error Pointer parameter
 RespTmout : Response Timeout parameter
 Retries : Retry Count parameter
 ErrOffs : Error/Status Offset parameter
 ARPTmout : ARP Timeout parameter
 ErrDelay: Command Error Delay parameter
 FltFlag: Float Flag parameter
 Flt St : Float Start parameter
 FltOffs : Float Offset parameter
Server

BIOffs: Bit Input Offset parameter
 WIOffs : Word Input Offset parameter
 OutOffs : Output offset parameter
 HoldOffs : Holding Register offset parameter
 FltFlag: Float Flag parameter
 FltSt : Float Start parameter
 FltOffs : Float Offset parameter