PLANET NAS-7410 - Manual (Page 7)

4-Bay SATA NAS RAID Server with iSCSI
NAS-7410
7
Space Saving & Tray-less Design
The NAS-7410 is designed to allow the installation of up to four 2.5”/3.5” SATA hard drives. Each
hard drive door has a multi-locking latch mechanism in order to prevent a door from being opened
easily. Each of these doors includes a tray and hard drive key that can be easily unlocked and
pulled out. Then users can easily attach the hard drive to the hot-swap hard drive tray with the
screws.
Automatic Data Protection by RAID & Hot Swap
The NAS-7410 provides advanced RAID configurations including RAID 0, 1, 5, 6 and 10 functions.
You can get the perfect compromise between speed and disk-failure proof, hardware-level data
protection. It also supports hot-swap design so that a failed drive can be replaced by hot swapping
without turning off the server.
Multiple LAN for Better Efficiency
The NAS-7410 features multiple functions to support LAN storage for better efficiency.
Fault Tolerance：When LAN1 of the NAS-7410 fails to connect to the network, LAN2 would take
over from LAN1 which is designed to ensure server availability to the network.
Load Balancing：When the traffic of LAN1 starts to get congested, then LAN2 would share the
traffic until the traffic of both LAN ports starts to get balanced. Load Balancing also incorporates
Fault Tolerance protection.
Link Aggregation：Combine LAN1 and LAN2 into a single channel to provide greater bandwidth.
Must be used with Link Aggregation switch.