Lldp refresh-interval, Lldp reinit-delay – PLANET SGSD-1022 User Manual
Page 605
User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
This parameter only applies to SNMP applications which use data stored in the LLDP MIB for network monitoring or
management.
Information about changes in LLDP neighbors that occur between SNMP notifications is not transmitted. Only state
changes that exist at the time of a notification are included in the transmission. An SNMP agent should therefore
periodically check the value of lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.
Example
Console(config)#lldp notification-interval 30
Console(config)#
lldp refresh-interval
This command configures the periodic transmit interval for LLDP advertisements. Use the no form to restore the
Default
Setting
.
Syntax
lldp refresh-interval seconds
no lldp refresh-delay
seconds - Specifies the periodic interval at which LLDP advertisements are sent. (Range: 5 - 32768 seconds)
Default Setting
30 seconds
Command Mode
Global Configuration
Command Usage
This attribute must comply with the following rule:
(refresh-interval * holdtime-multiplier) ≤ 65536
Example
Console(config)#lldp refresh-interval 60
Console(config)#
lldp reinit-delay
This command configures the delay before attempting to re-initialize after LLDP ports are disabled or the link goes down.
Use the no form to restore the
Default Setting
.
Syntax
lldp reinit-delay seconds
605