PLANET SGSD-1022 - Manual (Page 480)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Syntax
mac-authentication intrusion-action [block traffic | pass traffic] no mac-authentication intrusion-action Default Setting
Block Traffic
Command Mode
Interface Configuration
Example
Console(config-if)#mac-authentication intrusion-action block-traffic
Console(config-if)#
mac-authentication max-mac-count
Use this command to set the maximum number of MAC addresses that can be authenticated on a port via 802.1X authentication
or MAC authentication. Use the no form of this command to restore the default.
Syntax
mac-authentication max-mac-count count no mac-authentication max-mac-count
count - The maximum number of 802.1X and MAC-authenticated MAC addresses allowed. (Range: 1-1024)
Default Setting
1024
Command Mode
Interface Configuration
Example
Console(config-if)#mac-authentication max-mac-count 32
Console(config-if)#
network-access dynamic-vlan
Use this command to enable dynamic VLAN assignment for an authenticated port. Use the no form to disable dynamic VLAN
assignment.
Syntax
[no] network-access dynamic-vlan
Default Setting
Enabled
Command Mode
Interface Configuration
Command Usage
480