Switchport private-vlan host-association – PLANET SGSD-1022 User Manual
Page 588

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
promiscuous – This port type can communicate with all other promiscuous ports in the same primary VLAN, as well as
with all the ports in the associated secondary VLANs.
Default Setting
Normal VLAN
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
To assign a promiscuous port to a primary VLAN, use the switchport private-vlan mapping command. To assign a host
port to a community VLAN, use the private-vlan host association command.
To assign a promiscuous port or host port to an isolated VLAN, use the switchport private-vlan isolated command.
Example
Console(config)#interface ethernet 1/2
Console(config-if)#switchport mode private-vlan promiscuous
Console(config-if)#exit
Console(config)#interface ethernet 1/3
Console(config-if)#switchport mode private-vlan host
Console(config-if)#
switchport private-vlan host-association
Use this command to associate an interface with a secondary VLAN. Use the no form to remove this association.
Syntax
switchport private-vlan host-association secondary-vlan-id no switchport private-vlan host-association secondary-vlan-id -
ID of secondary (i.e., community) VLAN.
(Range: 1-4094, no leading zeroes).
Default Setting
None
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
All ports assigned to a secondary (i.e., community) VLAN can pass traffic between group members, but must
communicate with resources outside of the group via promiscuous ports in the associated primary VLAN.
Example
Console(config)#interface ethernet 1/3
Console(config-if)#switchport private-vlan host-association 3
Console(config-if)#
588