TA Triumph-Adler DC 6140L - Manual (Page 317)

8
8-121
Default Setting (System Menu)
6 Press the OK key. LAN Interface appears.
7 Press the U or V key to select the desired LAN
interface.
The available LAN interfaces are as follows:
Auto
10Base-Half
10Base-Full
100Base-Half
100Base-Full
8 Press the OK key. Completed. is displayed and the
screen returns to the Network Setting menu.
TCP/IP (IPv4) Setup
Set up TCP/IP to connect to the Windows network. Set the IP addresses, subnet masks, and gateway addresses.
The default settings are "TCP/IP Protocol: On, DHCP: On, Bonjour: Off".
NOTE: Prior to the IP address entries, obtain permission from the network administrator.
Use the procedure below to setup the TCP/IP (IPv4) setting.
1 In the Sys. Menu/Count. menu, press the U or V key to
select [System], and press the OK key.
A login screen will appear. Then, enter the user ID and
password with administrator privileges to log in, and
press [Login] (the Right Select key).
2 The System menu appears.
LAN Interface: a b
*********************
2 10Base-Half
3 10Base-Full 1 *Auto
Sys. Menu/Count.:a b
1 Report
2 Counter
*********************
[ Exit ]
3 System
Login User Name: L b
*******************
Login Password:
[ Login ]
System: a b
*********************
2 I/F Block Set.
3 Security Level
[ Exit ]
1 Network Setting