TA Triumph-Adler LP 218 - Manual (Page 56)

2-29
Chapt
er
2
S
e
tt
ing-Up
Options
5
With one hand holding the duplex unit in position, use a Phillips
screwdriver to tighten the screws that are permanently attached
to the back of the duplex unit.
Note
6
Connect the power cord to the printer and then turn the printer
on.
See “Connecting the Power Cord” on page 2-12.
See “Turning On the Printer” on page 2-15.
7
Generate a configuration page to verify that duplex unit is listed
under the Printer Configuration item.
See “Testing the Printer” on page 2-16.
◆ Hold up the duplex unit with your hand during installation until it
is secured to the printer with the screws.
PRINTER CONFIGURATION
Tray 2 = Not Installed
Tray 3 = Not Installed
Duplex Unit = Installed