Fluke commands compatibility, Fluke commands compatibility -16 – RIGOL M300 User Manual
Page 82

RIGOL
Chapter 3 Commands Compatibility
Programming Guide for DM3000
3-16
Fluke Commands Compatibility
The following table lists the
Fluke commands supported by RIGOL DM3000 series
digital multimeter. Before using these commands, please select the Fluke command
set using the CMDSet command (send the CMDSet FLUKE command). For more
details on this command, please refer to the “Command Set Introduction”on page 1-5.
Note: the functions of the Fluke commands in RIGOL DM3000 series digital
multimeter are listed in the “Function” column in the table below.
Fluke Command
Function
AAC
Enable the AC current measurement function.
ADC
Enable the DC current measurement function.
VDC
Enable the DC voltage measurement function.
VAC
Enable the AC voltage measurement function.
CONT
Enable the continuity measurement function.
DIODE
Enable the diode measurement function.
FREQ
Enable the frequency measurement function.
FREQ2
Enable the frequency measurement function on the secondary
display while the instrument is in AC measurement.
OHMS
Enable the resistance measurement function.
WIRE2
Switch to the 2-wire resistance measurement function.
WIRE4
Switch to the 4-wire resistance measurement function.
FUNC1?
Query the current main measurement function.
FUNC2?
Query the current secondary measurement function. It is only
available for AC measurement. For other measurement functions,
the query returns NULL.
CLR2
Clear the secondary function. This command is available only when
the frequency measurement function is enabled during AC
measurement.
DB
Enable the DB measurement function.
DBCLR
Exit the DB measurement function.
DBREF
Set the DB reference value. The reference value corresponding to
the parameter is as shown in the table below. The unit of reference
resistance is dBm.