RIGOL M300 - Manual (Page 45)

Chapter 2 Command System RIGOL
Programming Guide for DM3000 2-33
5. :UTILity:INTErface:LAN:MASK
Syntax
:UTILity:INTErface:LAN:MASK?
:UTILity:INTErface:LAN:MASK
Function Users define the subnet mask of the network currently connected
to the multimeter.
Explanation  The format of is “nnn.nnn.nnn.nnn” and all
“nnn” range from 0 to 255.
 The IP address configuration type should be Manual and both
DHCP and AutoIP should be disabled when you use this
command.
6. :UTILity:INTErface:LAN:GATEway
Syntax
:UTILity:INTErface:LAN:GATEway?
:UTILity:INTErface:LAN:GATEway
Function Users define the gateway of the network currently connected to the
multimeter.
Explanation  The format of is “nnn.nnn.nnn.nnn”. The first
“nnn” ranges from 0 to 223 (except 127) and the others range
from 0 to 255.
 The IP address configuration type should be Manual and both
DHCP and AutoIP should be disabled when you use this
command.
7. :UTILity:INTErface:LAN:DNS
Syntax
:UTILity:INTErface:LAN:DNS?
:UTILity:INTErface:LAN:DNS
Function Users define the DNS server address of the network currently
connected to the multimeter.
Explanation  The format of is “nnn.nnn.nnn.nnn”. The first
“nnn” ranges from 0 to 223 (except 127) and the others range
from 0 to 255.
 The IP address configuration type should be Manual and both
DHCP and AutoIP should be disabled when you use this
command.
8. :UTILity:INTErface:GPIB:ADDRess
Syntax
:UTILity:INTErface:GPIB:ADDRess?