RIGOL M300 User Manual
Page 71

Chapter 3 Commands Compatibility
RIGOL
Programming Guide for DM3000
3-5
current measurement.
Note: this command is only available in DC current
measurement function when the statistic function is
enabled.
FETCh:CURRent[:DC]:PTPeak?
Query the difference between the maximum and
minimum DC transient currents.
Note: this command is only available in DC current
measurement function when the statistic function is
enabled.
FETCh:VOLTage:AC:PTPeak?
Query the difference between the maximum and
minimum AC transient voltages.
Note: this command is only available in AC voltage
measurement function when the statistic function is
enabled.
FETCh:VOLTage[:DC]:PEAK:MAXimum?
Query the maximum DC transient voltage in DC
voltage measurement.
Note: this command is only available in DC voltage
measurement function when the statistic function is
enabled.
FETCh:VOLTage[:DC]:PEAK::MINimum?
Query the minimum DC transient voltage in DC
voltage measurement.
Note: this command is only available in DC voltage
measurement function when the statistic function is
enabled.
FETCh:VOLTage[:DC]:PTPeak?
Query the difference between the maximum and
minimum DC transient voltages.
Note: this command is only available in DC voltage
measurement function when the statistic function is
enabled.
[SENSe:]CAPacitance:NULL[:STATe]?
[SENSe:]CAPacitance:NULL[:STATe]
{ON|OFF}
Query and set the state of the NULL function of
capacitance measurement.
[SENSe:]CAPacitance:NULL:VALue?
[{MIN|MAX}]
[SENSe:]CAPacitance:NULL:VALue
{
Query and set the NULL value of capacitance
measurement.
[SENSe:]CAPacitance:RANGe:AUTO?
Query and set the state of the auto range function