To set up measurement parameters, To set up measurement parameters -41, Ac filter – RIGOL DM3058 User Manual
Page 63
RIGOL
User’s Guide for DM3058/DM3058E
2-41
To Set up Measurement Parameters
Press
to set measurement parameters for DC Voltage, DC Current and
Continuity.
The parameters have been configured when the multimeter leaving factory. So you
can either measure directly or modify them to meet your requirements.
AC Filter
AC Filter is applicable for DC Voltage and DC Current measurement.
While either DC Voltage or DC Current function is selected, press
Filter,
enter the menu shown below. If AC component existing in inputted DC signal, it
can be filtered by AC Filter so as to make the data more exactly.
Figure 2-57 Open/Close AC Filter