RIGOL DM3058 - Manual (Page 61)

RIGOL
User’s Guide for DM3058/DM3058E 2-39
Vice Display, math operation will be closed automatically and Vice Display will
show the second selected function normally.
 If Math function (REL) is used in Main Display, when open Vice Display, the
result will still be shown in Main Display and Vice Display will show the second
selected function normally.
(3) If Sensor is used in Main Display, set the display mode (  Disp All), then
the result (corresponding value) will be shown in Main Display and the current
measurement value is shown in Vice Display.
(4) Auto Range is adopted by Vice Display. If the same measurement function is
used in both the display, so does the range.
(5) Measured data in Vice Display cannot be saved into “History”.
2. Save Current Settings Quickly
Press  , and then press any Setn key, the instrument will store
current instrument settings to corresponding memory with default filename
“Setn”. You can also finish this operation through the
function (see the
Store and Recall section).
3. Open REL Settings Interface Quickly
In general measurement interface, press , then press the REL menu to
enter Figure 2-65 Relative operation setting interface immediately.