Retrotec DM-2 - Manual (Page 27)

Page 27 of 72
©Retrotec Inc. 2012
Mn Exhaust Fan Flow
Meter
Mn TrueFlow Grid Infiltec E3
3.2.1 Enable and Disable Devices
To simplify the device selection process, it is possible to disable devices that will not be used. Disabled
devices are saved in system memory, and will remain disabled upon subsequent uses. They can always
be enabled if necessary.
When you choose “No” for any one of the devices, you eliminate all the ranges as well. Each Device
can be enabled individually.
To enable/disable Devices
1. From the main gauge screen, press [Setup] to access the “Setup” menu.
2. Press [  ] or [  ] to select "Device Setup" in the list. Press [Enter].
3. Press [

] or [

] to select a device. Press [

] or [

] to toggle between "Yes" or "No" next
to each device. Selecting "Yes" for a device enables that device to be selected on the Main
Screen.
4. Press [Exit] to return to the “Setup” Menu, press [Exit] again to return to the Main Screen.
3.2.2 Enable and Disable Range Configurations
It is also possible to enable and disable Range Configurations for each of the Devices being used. This
will eliminate the need to scroll through each Range when pressing [Range Config] when it can be