RISCO Group ACIS - Manual (Page 11)

User Manual for ACIS Version
Uncontrolled when printed © RISCO Group 2
4. After registering, you Configure Controller and create doors as required.
5. After doors are created, you can configure sensors and relays as required. Each door has four relays and
four sensors and two readers. A door can accommodate up to four readers.
6. The relays and sensors that are not connected to any door are external relays and sensors. You configure
external relays and sensors along with controller in the Configure Controller screen.
7. After the proxy is registered and configured, you may perform Built-in Test for Proxy, which provides the
Memory information, CPU Information, Virtual Memory Statistics, Stack Memory, RAM Information, Flash
Information, Active/Backup Proxy Connections and Hardware Information about the Proxy.
8. After the controller is registered and configured, you may perform Built-in Test for Controller, which
provides the Memory information, CPU Information, Virtual Memory Statistics, Stack Memory, RAM
Information, Flash Information, Active/Backup Proxy Connections, Access Authorization Data Count, ACIB
Communication Status and Hardware Information about the Controller.
9. You can upgrade Proxy, ACCB, ACIB, and Reader versions using Firmware Download.
After these tasks are performed, there are some generic tasks that you can do as per your requirement:
You can add a Template Proxy. A Template Proxy is not an actual device but created in case you want to
configure the Proxy settings and keep it ready till the time an actual device is available. When you obtain the
Real Proxy, you can replace the Template Proxy with the Real Proxy. Similarly, you can add and configure a
Template Controller and replace it with the real controller whenever required.
You can transfer proxies between sections provided there are no devices connected to a Proxy. You can transfer
controller between sections. The default configurations for the controller are applied. The doors created for the
controller in the original section are deleted.
You can create new sections in the account. The Main Installer can create other installers and assign sections to
them. Only the main installer has access to all the sections in the account. You can view the section level reports
for Proxy Configuration, Controller Configuration, Door Configurations and other system parameters in ACIS.
The procedures to perform each of these tasks are explained in this manual.