MCZ Yari AIR - Manual (Page 39)

2 3
1 4
37
6-SAFETY DEVICES AND ALARMS
Technical Dept. - All rights reserved - Reproduction is prohibited
Other signals on the display
The following table summarizes that messages that most commonly appear on the display panel.
MESSAGE ON THE DISPLAY PANEL MEANING
OFF The stove is off.
MANUAL The stove is in manual mode.
ON The stove is on.
START-UP Ignition sequence.
P-1 .... P-5 The stove in manual mode at the indicated speed (1,2,3,4 or 5).
ECO-STOP Stove in automatic mode with "switch-off due to temperature".
20°C Example of room temperature.
MON...SUN Days of the week.
DAY Day.
HOURS Hours.
MINUTES Minutes.
ACCESS KEY Access key.
SET FAN Setting.
CLEANING Automatic cleaning of the brazier in the set period of time.
ON-ECO The stove is on in automatic mode and the room temperature is satisfied.
SHUTTING THE STOVE DOWN
The stove can be switched off at any time and in any position.
NEVER SHUT THE STOVE DOWN BY CUTTING OFF THE ELECTRICITY SUPPLY.
Always let it complete the shutdown cycle, otherwise the structure could be damaged and/or problems could arise
in future start-ups.
To switch the stove off press button 5 on the control panel for a few seconds, or buttons 2 and 3 together on the remote
control.
The message “OFF” will appear on the display. At this moment the shutdown cycle begins, in which the pellet loading screw stops, while
the smoke extractor and the hot air exchanger remain on until the temperature of the stove has dropped to an acceptable level.
The stove will only shut off definitively after 20-30 minutes and, nevertheless, not until the smoke temperature drops below 50°C.
This occurs to allow the combustion fumes to be ducted into the flue pipe by means of the extractor.
It also means that there is total recovery of the heat yielded by combustion to the structure of the stove.