MCZ Yari AIR - Manual (Page 19)

17
3-INSTALLATION AND ASSEMBLY
Position the product without its cladding and connect it to the chimney. Once the connections are complete, assemble the cladding
(ceramic or serpentine sides).
If the product must be connected to an exhaust pipe that goes through the rear wall (to enter the chimney), make sure not to force it in.
Adjust the 4 feet (J) to level the stove for the smoke exhaust and the pipe to be coaxial. The ceramic/serpentine sides must not be fitted
when the feet are adjusted as this is carried out inside the cladding. A rear foot is adjusted through the triangular hole on the back of the
product (detail A).
Attention!!
Do not use and/or force the smoke exhaust pipe when handling the product as it can be damaged.
1 - Turn the feet clockwise to lower
the stove
2 - Turn the feet counterclockwise to raise
the stove
Technical Dept. - All rights reserved - Reproduction is prohibited