MCZ Yari AIR - Manual (Page 33)

MODO
AUTOMATICO
40°C
MODO
AUTOMATICO
40°C
MODO
AUTOMATICO
40°C
MODO
AUTOMATICO
40°C
MODO
AUTOMATICO
40°C
MENU 5
SET
ECO-STOP
ON (OFF)
ATTIVA
ECO-STOP
31
5 - MODE AND SETTINGS
Technical Dept. - All rights reserved - Reproduction is prohibited
• unscrew the protective cap from the probe
• Pass the two wires through the protective cap and thread them into the hole along with the probe.
• Pull the two wires to connect them to the board, on clamp 13 of the electronic board.
• Close the protective cap back up
AUTOMATIC MODE WITH ECO-STOP
By enabling this option from the relative menu entry, you will change stove behaviour in automatic mode: when the temperature set by
the user is reached (on internal or external thermostat), instead of modulating its power, the stove will switch off displaying the words
“ECO STOP” and will switch back on when the room requires more temperature (not before the interval required by the stove to cool down
is over). This option is only advisable if the stove operates in small or very insulated rooms
Enabling ECO-STOP mode
• Press the 6 MENU button on the control panel, then button 1 until you reach the 5th screen with the message “SET ECO-STOP”;
• Press 6 MENU again and set ON on the display screen using button 1 or 2;
• Press button 6 (or button 5) to exit.
Follow the same procedure to disable the ECO-STOP function.
Operating example:
If the room temperature reading provided by the local probe positioned on the stove is 15°C, and the temperature setting on the
thermostat is 20°C, the stove will gradually switch to the 5th power until it reaches 20°C. If the temperature is satisfied for 20' the stove
will automatically switch off temporarily, displaying the words “ECO STOP”. When room temperature drops below the set value on the
thermostat (e.g. 18°C), and sufficient switch-off time has elapsed, the stove will automatically restart and run until 20°C are reached
again. If, on the other hand, the temperature read by the room probe continues to exceed that set on the thermostat (e.g. 20-21°C), the
stove will remain off and the words “ECO STOP” will appear on the display.
In this mode, the user can switch the stove on by resetting the thermostat to a temperature that is higher than that in the room, or by
switching to "Off" mode by pressing button 5 for a few seconds and then switching the stove on by pressing the same button again.
There is no need to reset the “eco stop” mode as this is saved from when last used.
Switching from automatic to manual mode
To switch back to MANUAL mode from AUTOMATIC mode, do the following:
press and hold button 2 down until the temperature exceeds 40°C. At that point the words “MODO MANUALE” (MANUAL MODE) will appear
on the display and the light on the  symbol will come on.