MCZ Yari AIR - Manual (Page 23)

21
3-INSTALLATION AND ASSEMBLY
Technical Dept. - All rights reserved - Reproduction is prohibited
BEFORE START-UP
GENERAL PRECAUTIONS
Remove all components that could burn from the brazier and glass (manual, various adhesive labels and any polystyrene).
Check that the brazier is positioned correctly and rests properly on the base.
The first start-up may not be successful as the feed screw is empty and does not always manage to load the required
amount of pellets in the brazier in time for the fire to be regularly ignited.
CLEAR THE ALARM CONDITION FOR FAILURE TO IGNITE. REMOVE ANY PELLETS LEFT IN THE BURNER AND REPEAT
IGNITION BY PRESSING FOR A FEW SECONDS ON BUTTON 5.
If a flame does not ignite after a number of failed start-ups, even though the pellet supply is correct, make sure the brazier is set in place
correctly, which must be interlocked in its seat and free from any ash deposits. If no anomaly is found during this inspection, there
may be a problem with the product components or installation may not be correct.
REMOVE THE PELLETS FROM THE BRAZIER AND CONTACT AN AUTHORISED TECHNICIAN.
Avoid touching the stove during the initial start-up, as the paint hardens during this phase. If you touch the paint,
you may expose the steel surface.
If necessary, touch up the paint with the spray can in the original colour (see the "Accessories for pellet stoves" section).