Epson PLQ-30 - Manual (Page 67)

Auto I/F wait time (Seconds)
When the printer is in the auto interface mode and it receives no data from the currently selected
interface for the amount of time specified with this setting, it determines which interface is receiving
data and switches to that interface. You can specify either 10 or 30 for the auto interface wait time.
When the printer turns on in the PR2 mode, this mode is not activated.
Print direction
You can select auto print direction (Auto), bidirectional printing (Bi-D), or unidirectional printing
(Uni-D). Printing is normally bidirectional; however, unidirectional printing allows for precise
vertical printing alignment.
When set to Auto, the printer analyzes the data and uses unidirectional printing for any lines which
require vertical printing alignment.
0 slash
The zero character has a slash ( ) when this feature is set to On; it has no slash (0) when set to Off. The
slash allows you to easily distinguish between the uppercase letter “O” and a zero.
Font
You can select from a variety of fonts.
Pitch (cpi)
This setting allows you to set one of six pitches.
Character table
You can select among various character tables. This setting is used when you print without using the
printer driver.
When using the printer driver, change the settings on the printer driver. For details, see “Printer
Driver Settings Overview” on page 29.
International character set for italic table
You can select among several international character sets for the italic character table. Each character
set contains eight characters that vary depending on the country or language, so you can customize the
italic table to suit your printing needs.
PLQ-30/PLQ-30M User’s Guide
Control Panel 67