Epson PLQ-30 - Manual (Page 56)

Menu Values (default in bold)
Displacement *3 Standard, +10, +20
Duplicate *3 Off, On
Retry *3 1, 3
*1 When the printer turns on in the PR2, WNI4915, or IBM4722 mode, Packet mode is set to OFF.
*2 When the printer turns on in Passbook or Rear Paper Guide mode, Roll paper mode is not available.
*3 These settings are available only when magnetic stripe reader/writer is installed.
*4 This settings is effective when the format of IBM3604 or IBM4746 is selected.
*5 These settings are unavailable when the printer turns on in WNI4915 mode.
Draft speed
This setting allows you to set printing speed.
Parallel I/F bidirectional mode
The Parallel Interface bidirectional transfer mode is used when this feature is set to On. If bidirectional
transfer mode is unnecessary, select Off.
Packet mode
Make sure to select Auto when you print from Windows applications using the printer driver that was
downloaded from the Web site. Set this feature to Off if you have connection troubles while printing
from applications based on other operating systems. When the printer turns on in the PR2, WNI4915,
or IBM4722 mode, this mode is set to Off.
Baud rate (bps)
Use this option to set the data transfer rate (baud) for the serial interface. The baud rate is measured in
bits per second (bps).
Data length (bit)
Set the data length of the serial interface to 7 or 8.
Parity
When this option is set to None, parity checking is disabled. The parity bit, if used, provides a basic
form of error detection.
PLQ-30/PLQ-30M User’s Guide
Control Panel 56