Epson PLQ-30 - Manual (Page 57)

Passbook
When you use single sheet or passbook, set this option to On. When you use multipart forms, set this
option to Off.
Binding
You need to set the method for binding when you use a passbook. Select Horizontal for a
horizontal-fold passbook or Vertical for a vertical-fold passbook.
Thin paper
When you use thin paper, set this option to On. This mode is activated when you select On and the
Passbook
mode is set to Off.
Buzzer
If you set this feature to On, the printer beeps when an error occurs. See “Using the Error Indicators”
on page 72 for more information on printer errors. If you do not want the printer to beep, select
Off
.
Paper width measurement
You can set the timing when the printer measures the width of the paper. When you select After
loading
, the printer measures the width just after it loads the paper. When you select Before
printing , it makes the measurement just before printing the first line.
Right paper edge detection
This setting allows you to determine whether the printer prints excess data when the data is longer
than the paper width. When you select On, the excess data is not printed. When you select Off, the
printer prints the excess data on the next line.
Low-noise mode
When this mode is set to On, the noise is reduced, but the printing speed is slower.
Broken pin compensation
When this feature is On, printing is done at normal quality if one of the 24 pins is broken. You need to
set the broken pin number at the Broken pin number setting.
PLQ-30/PLQ-30M User’s Guide
Control Panel 57