Epson PLQ-30 - Manual (Page 21)

6. Press the F1/Eject button to move the top-of-form position up on the page, or press the F2 button
to move the top-of-form position down on the page. Each time you press the F1/Eject or F2
button, the printer makes a short beep. Pressing these buttons executes micro feed in 0.282 mm
(1/90-inch) increments.
Note:
The top-of-form position can be set from 1.0 mm to 33.8 mm.
7. Insert a sheet of A4 paper into the front slot. The printer prints triple H in capitals (HHH) on the
current top-of-form position and ejects the sheet. You may continue to adjust the position by
pressing the F1/Eject and F2 buttons and checking the position by inserting another sheet.
8. After finishing the adjustment, turn off the printer. The setting does not change even if the printer
is turned off.
Adjusting the printing start position
The printing start position is the horizontal position on the page where the printer starts printing. If
the printout appears too for the left or right on the page, you can use this function to adjust the printing
start position.
The print start position can be set for each emulation.
Target Printer Mode Emulation
Olivetti Mode PR2
Wincor Nixdorf Mode WNI4915
IBM Mode IBM4722
EPSON Mode ESC/P2, IBM PPDS, ESC/P2+ESC/MC
Follow these steps to adjust the printing start position:
PLQ-30/PLQ-30M User’s Guide
Paper Handling 21