Epson PLQ-30 - Manual (Page 62)

Auto CR
When auto carriage return is set to On, each line feed (LF) code is accompanied by a carriage return
(CR) code so the printer moves the next printing start position to the left margin. When this setting is
set to Off, you must send a CR code after the line feed code to move the printing start position to the left
margin.
Columns
You can select the number of columns in one line.
Side
This setting allows you to switch the printing start position reference to the left or right side of the
paper. When Left is selected, printing is normal and starts from the first character with the left edge of
the paper. When Right is selected, printing starts from the last column of the number of columns set in
Columns with the right edge of the paper as the reference.
TOF position for PR40+
When you select On in this option and PR40+ in PR2 Emulation, the top-of-form position is set to 7.4
mm which is unique to the PR40+ mode. When you select Off and PR40+, the top-of-form position is
set to the same position as in the PR2 and PR54+ modes (the factory set default is 4.2 mm).
Wincor Nixdorf Mode Settings
Menu Values (default in bold)
Interface Serial, Parallel, USB
Software WNI4915
WNI4915 Mode Settings
Depending on the factory default, the WNI4915 mode may not be available. In this case, the PR2 mode
is implemented instead. See “PR2 Mode Settings” on page 59.
Menu Values (default in bold)
Font Draft, Roman, Sans Serif
Pitch (cpi) 10, 12, 15, 17.1, 20, Proportional
Character table Italic, PC437, PC850, ISO 8859/2, ISO 8859/5, ISO 8859/7, ISO 8859/8,
ISO8859/9, ISO 8859/15
Serial I/F Protocol DTR, XON/XOFF, XON/XOFF2
PLQ-30/PLQ-30M User’s Guide
Control Panel 62