beautypg.com

Pressure Systems 98RK-1 User Manual

Page 143

background image

Pressure Systems, Inc. 98RK-1 & 9816 User’s Manual©

Page 141

www.PressureSystems.com

If you desire to connect with any module on the network, NUSS allows you to do that through its
UDP/IP protocol commands (see Chapter 3).



All of this can become an invaluable source of information for troubleshooting your modules(s).
See Chapter 5, Section 5.2 regarding updating the module firmware.

6.1.3.4

Verifying Host TCP/IP Communications


At this point, the NetScanner

System module should be configured to obtain its IP address

through either Static or Dynamic IP assignment. The module’s IP address must be assigned
and known in order to proceed. The host computer has also been configured for TCP/IP
protocol and assigned an IP address compatible with the NetScanner

System IP address. A

simple method to verify proper operation is through the ping utility. This is a simple TCP/IP
utility that is found in Windows

®

-based operating systems as well as most other TCP/IP

packages. The ping utility simply sends a test packet to the specified IP address and waits for
reply to be returned. The NetScanner

System Ethernet modules are programmed to reply to

these ping requests.

To run the ping utility from Windows

®

, follow these steps. Left click the Windows START

button. Move the mouse pointer to 'RUN' and left click on it. At the prompt, type ‘ping
xxx.xxx.xxx.xxx’
where xxx.xxx.xxx.xxx represents the IP address of the device to test. The IP
address of an Ethernet NetScanner

System module should be used. A small DOS window

will appear as the ping application executes. The ping program will report either a reply was
received or it failed to receive a reply. If the ping application reported receiving a reply, the host

This manual is related to the following products: