beautypg.com

Re-boot module (udp/ip command 'psireboot') – Pressure Systems 98RK-1 User Manual

Page 100

background image

Pressure Systems, Inc. 98RK-1 & 9816 User’s Manual©

Page 98

www.PressureSystems.com

RE-BOOT MODULE (UDP/IP Command 'psireboot')

Purpose: To unconditionally “reboot” a specified module.

Command

psireboot ethadr
where ethadr is the Ethernet Address of the specified module in the
following special hex-digit format ‘xx-xx-xx-xx-xx-xx’

Response

none (module reboots).


Description: When a NetScanner

System module receives this broadcast command (by

continuously monitoring port 7000) it responds by restarting its firmware
immediately. The result is essentially the same as a power up restart, in that any
TCP/IP connection is lost, and the module returns to its normal startup state.
The host must wait long enough for the reboot process to be completed before is
can again address the module.


Example:

Reboot a specified module on then network.

"psireboot 12-34-56-78-90-12"

Response:

(None)


This manual is related to the following products: