Epson USN 52L - Manual (Page 60)

Krautkramer USN 52R/USN 52L Issue 05, 02/00 5-15
SET# Selection of data set
You are able to select the required data set number with
this function. If necessary, an allocated data set name
will be displayed at the same time.
Additionally, you can give each data set a name with
which it is stored. Refer to Chapter 5.10
Entering and
displaying data set names.
Operation:
– Select a number between 1 and 140 (USN 52R) / 1
and 100 (USN 52L) with M.
STORE Storing the instrument settings
With this function you store the active instrument set-
tings and the active A-scan under the number indicated
in SET#.
If the data set is already allocated (symbol
■) you can-
not overwrite it. You must firstly clear the old data set.
Operation:
– Switch to ON with M to store the setting. When the
process is completed, the display automatically
changes to OFF.
– Acknowledge system safety prompt with F.
– If required, enter the required additional information
in the displayed MEMO menu (please see chapter
5.10).
Clearing the instrument setting
An instrument setting which is stored can be over-
written after you have disabled the write protection.
You can reallocate the data set.
Operation:
– Simultaneously press N and O in the RECALL
function.
– Acknowledge system safety prompt with F.
Write protection is disabled. The symbol
■ is deleted.
The data set can now be reallocated.
Adjustment of the USN 52R/USN 52L Operation
Krautkramer USN 52R/USN 52L Issue 05, 02/00 5-15
SET# Selection of data set
You are able to select the required data set number with
this function. If necessary, an allocated data set name
will be displayed at the same time.
Additionally, you can give each data set a name with
which it is stored. Refer to Chapter 5.10
Entering and
displaying data set names.
Operation:
– Select a number between 1 and 140 (USN 52R) / 1
and 100 (USN 52L) with M.
STORE Storing the instrument settings
With this function you store the active instrument set-
tings and the active A-scan under the number indicated
in SET#.
If the data set is already allocated (symbol
■) you can-
not overwrite it. You must firstly clear the old data set.
Operation:
– Switch to ON with M to store the setting. When the
process is completed, the display automatically
changes to OFF.
– Acknowledge system safety prompt with F.
– If required, enter the required additional information
in the displayed MEMO menu (please see chapter
5.10).
Clearing the instrument setting
An instrument setting which is stored can be over-
written after you have disabled the write protection.
You can reallocate the data set.
Operation:
– Simultaneously press N and O in the RECALL
function.
– Acknowledge system safety prompt with F.
Write protection is disabled. The symbol
■ is deleted.
The data set can now be reallocated.
Adjustment of the USN 52R/USN 52L
Operation