2 safety, 2safety – KACO Powador Argus 16S DCS User Manual
Page 6

Safety
Page 6
Operating Instructions Powador Argus 16S DCS, 24S DCS_EN
2
Safety
DANGER
Danger due to lethal voltages. Lethal voltages are present within the unit and on the power
supply lines. Therefore, only skilled and authorised electricians may install and open the unit.
The string monitoring box must be installed by an authorised electrician who is responsible for the adherence to all
current standards and regulations. The proper and safe operation of this unit requires proper transportation,
storage, assembly and installation, as well as careful operation and maintenance.
The string monitoring box may only be operated by persons who have read and understood the operating instruc-
tions. Only authorised electricians who have read and fully understood all of the safety instructions contained in
these operating and installation instructions, as well as other instructions concerning assembly, operation and main-
tenance, may work on this unit. When the unit is operating, certain parts of the unit unavoidably carry hazardous
voltages, which can lead to death or severe injury.
The precautions listed below should be followed in order to minimise the risk of death or injury:
•
The unit must be installed in compliance with safety regulations, as well as any other applicable national or
site-specific regulations. To ensure operational safety, proper grounding, conductor dimensioning and appropri-
ate protection against short circuiting must be provided.
•
Keep all covers on the unit closed during operation.
•
Prior to performing any visual inspections or maintenance, ensure that the power supply has been disconnected
and is prevented from being switched back on inadvertently.
•
Never touch the electrical connections if it is necessary to take measurements while the power supply is switched
on.
•
Remove all jewellery from your wrists and fingers.
•
Make sure that the testing equipment is in good and safe operating condition.
•
Stand on an insulated surface when working on a unit that is switched on.
•
Follow the instructions contained in these operating and installation instructions and observe all other danger,
warning and safety information.
This is not an exhaustive list of every measure required for the safe operation of the unit.
Contact your specialist dealer if any specific problems arise which are not sufficiently covered for the purposes of
the buyer.