KACO Powador Argus 16S DCS - Manual (Page 26)

Controller Circuit Board
Page 26 Operating Instructions Powador Argus 16S DCS, 24S DCS_EN
8.4.2 Display: “ENTER SLAVE ADDRESS”
You can change the address of the individual combiner box circuit boards from this display.
8.4.3 Display: “Zero-Scale Configuration”
You can calibrate an individual combiner box circuit board to zero from this display. The jumper must be inserted in
exactly one combiner box circuit board. After you press the RIGHT button, the system will perform the calibration.
Make sure that no current is flowing through the strings during the calibration.
Figure 13: Zero-Scale Configuration