Yaskawa DriveWizard AC Drive - Manual (Page 41)

2. Select the inverter fam to create the new file. Only the inverters
aking your
ily that you wish
supported in the selected database will appear in the window. After m
selection, click on
OK and the dialog box in Figure 4.11 opens.
3. box.
4. e number of
the drive that the file is to be used in. The software number can be found in drive
r U1-1 for GPD515/G5, E7, F7, G7, & P7 and U-10 for GPD305/J7 &
Figure 4.11: Selecting Inverter Information
Select the KVA or rating of the drive by making a selection from the drop down
See the section of this manual on Inverter Initialization for an explanation of the model
number.
Next enter the drive software number. This number should match the softwar
monito
GPD315/V7.
G5 HHP softw
would be ente 4
When the first digit of the software number starts with a 0 (in the case of
are numbers, use a 5 digit number. Example: G5HHP software 0211
red as 10211. You must enter the proper software number.
o NOT use the default software number to create a file because with some
5. control mode of the drive (refer to this manual section on inverter initialization
D
drive families as it may cause DriveWizard
™
to omit some parameters that
you may not be aware of. The default number is just a place-holder.
Select the
for more details). Click on OK when finished.
6. A warning message (Figure 4.12) will come up indicating that if the designated software
number that you entered in the software number window is not in the selected database,
the latest software number in the database will be used as a default. Click on OK to
continue.
N
File Menu
ote!
41