Yaskawa iQpump Controller User Manual User Manual
Iqpump controller, User manual
Table of contents
Document Outline
- Warnings and Cautions
- Introduction
- Physical Installation
- 1.1 iQpump Model Number and Enclosure Style
- 1.2 Confirmations Upon Delivery
- 1.3 Component Names
- 1.4 Exterior and Mounting Dimensions
- 1.5 Heat Loss Data
- 1.6 Checking and Controlling the Installation Site
- 1.7 Installation Orientation and Clearances
- 1.8 Removing and Attaching the Terminal Cover
- 1.9 Removing/Attaching the Digital Operator and Front Cover
- Electrical Installation
- Digital Operator
- Start-Up
- Basic Programming
- Diagnostics & Troubleshooting
- Maintenance
- Parameters
- Capacity Related Parameters
- Specifications
- Communication
- Peripheral Devices
- E.1 Branch Circuit Short Circuit Protection
- E.2 Branch Circuit Overload Protection
- E.3 Peripheral Devices
- E.4 Third Party Serial Communication Converters RS232-RS485 / USB - RS485 Converters
- E.5 SCADA Software for iQpump Drive (SW.iQp.01)
- E.6 iQpump Drive Energy Savings Predictor with Carbon Footprint Calculation Sotware (SW.ESP.03)
- E.7 iQpump Drive Harmonics Estimator (SW.HE.04)
- Electromagnetic Compatibility
- Quick Setup Procedures
- G.2 Set-up Procedures Included in this Appendix
- G.3 Well Draw Down Function
- G.4 Sleep/Sleep Boost Function
- G.5 Utility Delayed Start Function
- G.6 Start Level Function
- G.7 Low City Pressure or Low Suction Inlet Pressure
- G.8 Lube Pump Digital Output for Deep Well Irrigation
- G.9 iQpump Software Multiplexing Set-up
- G.10 First In First Out (FIFO) Description
- G.11 Anti-No Flow Simplified Setup