Yaskawa iQpump Controller User Manual - Manual (Page 70)

3.7 Parameter Editing Example
70 YASKAWA TM.iQp.06 iQpump Controller User Manual
3.7 Parameter Editing Example
Table 3.14 provides an example of how to change parameter C1-02 (Deceleration Time 1) from 30 seconds to 40 seconds.
Table 3.14 Changing a Parameter in the Programming Menu
Step Number Digital Operator Display Description
1 The drive is first powered up.
2 Press the MENU key to scroll to “Operation” menu.
3 Press the MENU key to scroll to “Pump Quick Setup” menu.
4 Press the MENU key to scroll to “Programming” menu.
5 Press the DATA / ENTER key to enter “Programming” menu.
6 Press the INCREASE key until C1-01 (Accel / Decel) is displayed.
7 Press the SHIFT / RESET key to move flashing digit to the right.
8 Press the INCREASE key to display C1-02 (Decel Time 1).
9 Press the DATA / ENTER key to access setting display.
10 Press the SHIFT/RESET key to move the flashing digit to the right.
U1-02 = 0.00Hz
U1-91 = 0.00PSI
-DRIVE- Rdy
Auto: Setpoint Ref
U1-01 = 0.0PSI
-DRIVE-
** Main Menu **
- - - - - - - - - - - - - -
Operation
Pump Quick Setup
-ADV-
** Main Menu **
- - - - - - - - - - - - - -
Programming
-ADV-
Initialization
- - - - - - - - - - - - - - - - - - - -
A1 -01= 0
Select Language
-ADV-
Accel/Decel
- - - - - - - - - - - - - - - - - - - -
C1 -01= 1.0sec
Accel Time 1
-ADV-
Accel Time 1
- - - - - - - - - - - - - - - - - - - -
C1- 01 = 30.0sec
(0.0~6000.0)
“30.0sec”
-ADV-
Decel Time 1
- - - - - - - - - - - - - - - - - - - -
C1- 02 = 30.0sec
(0.0~6000.0)
“30.0sec”
-ADV-
Decel Time 1
- - - - - - - - - - - - - - - - - - - -
C1-02= 0 030.0sec
(0.0~6000.0)
“30.0sec”
-ADV-
Decel Time 1
- - - - - - - - - - - - - - - - - - - -
C1-02= 0 0 30.0sec
(0.0~6000.0)
“30.0sec”