beautypg.com

Figure 3.4.3.7 canceling g45 to g48 by g28 (g30) – Yaskawa YASNAC PC NC Programming Manual User Manual

Page 86

background image

3 - 36

YASNAC PCNC Programming Manual

Chapter 3: Movement Control Commands

FIGURE 3.4.3.6 Offset Applied from the Preceding Block

(e) Canceling G45 to G48 by G28 (or G30)

Note

1:

Although offset is applied to the intermediate positioning point specified in N4, the machine
origin is not offset.

2:

Axis movement specified in N5 is executed in the following manner according to the setting
for pm4010.
Offset cancel is selectedbypm4010: Movement to P1
Offset not cancel is selected by pm401C: Movement to P2

FIGURE 3.4.3.7 Canceling G45 to G48 by G28 (G30)

See also other documents in the category Yaskawa Equipment: