Yaskawa YASNAC PC NC Programming Manual - Manual (Page 7)

vi
YASNAC PCNC Programming Manual Introduction
USING THIS MANUAL
This manual decribes the procedures for operating the
`6TI68ÃQ8ÃI8Ã.
RELATED INFORMATION SOURCES
For additonal information, refer to the following manuals:
CAUTIONS
This manual describes all the option functions (identified by the “*” symbol) but some of these may not
be available with your YASNAC PCNC. To determine the option functions installed in your PCNC,
refer to the specification document or manuals published by the machine tool builder.
Unless otherwise specified, the following conditions apply in programming explanations and
programming examples.
l Metric system for input and metric system for output / movement
l Zero point in the base coordinate system
l Reference point
Yaskawa has made every effort to describe individual functions and their relationships to other functions
as accurately as possible. However, there are many things that cannot or must not be performed and it is
not possible to describe all of these. Accordingly, readers are requested to understand that unless it is
specifically stated that something can be performed, it should be assumed that it cannot be performed.
Also, bear in mind that the performance and functions of an PCNC machine tool are not determined
solely by the PCNC unit. The entire control system consists of the mechanical system, then machine
operation panel and other machine related equipment in addition to the PCNC. Therefore, read the
manuals published by the machine tool builder for detailed information relating to the machine.
TITLE OF DOCUMENT CONTENTS
YASNAC PCNC Programming Manual
(YEA-SIA-C844-2.2)
PCNC Program creation instructions
YASNAC PCNC/PLC Programming Manual
(YEA-SIA-C844-0.1)
PLC Program creation instructions
YASNAC PCNC I/O Signal Manual
(YEA-SIA-C844-2.3)
Describes functions between PCNC and PLC
YASNAC PCNC Connection Manual
(YEA-SIA-C844-0.2)
Instructions for connecting PCNC with machines,
machine interface and peripheral equipment
YASNAC PCNC Maintenance Manual
(YEA-SIA-C844-2.9)
Describes service and maintenance procedures.