Yaskawa YASNAC PC NC Programming Manual - Manual (Page 245)

4 - 108
YASNAC PCNC Programming Manual Chapter 4: Enhanced Level Commands
(b) Tool life control data
The data used by the tool life control function is stored as the tool group file. The data in
this file is retained even after the power is turned OFF.
Table 4.3.3.2 Tool Life Control Data
Title Description
T NO (tool number) The number assigned to the tool for which tool life is
controlled.
H NO (tool length offset num-
ber (H) The tool length offset number corresponding to the set
tool number
D NO (tool diameter offset
number (D)) The tool radius offset number corresponding to the set
tool number
LIFE (tool life) The service life of the tool set for the tool number
USED (tool used data) Courted used data of the tool set for the tool number
STS (status) Status of the life of the tool set for the tool number
OVER/SKIP
.LIFE TYPE Tool life control data for each tool group
TIME:
1 to 9999
COUNT 1 to 9999
DIST 1 to 9999
DRILL: 1 to 9999