Yaskawa YASNAC PC NC Programming Manual - Manual (Page 309)

4 - 172
YASNAC PCNC Programming Manual Chapter 4: Enhanced Level Commands
€ Macroprogram call up is specified as indicated below.
G65 P9061 X • • • Y • • • Z • • • R • • • I • • • J • • • K • • • T • • • Q • • • D • • • F • • • E
• • • ; where,
X, Y: Absolute coordinate value of start point (lower left end of pocket)
Z: Absolute position of the bottom of pocket
R: Absolute position (level) for tool return at rapid traverse
I, J: Length, of pocket in the X- and Y-axis direction (unsigned)
K: Allowance for finishing (allowance to be left, unsigned) “0” if not specified.
T: Width of cut ratio (in % of tool diameter)
Width of cut = Tool diameter × T/100
Q: Depth of cut per cycle (unsigned)
D: Tool of offset number
F: Feedrate in the XY plane
E: Feedrate for Z-axis cut-in
(Up to a level 1 mm above the previously cut level, “E × 4“)