Yaskawa F7 to A1000 - Manual (Page 54)

10 Appendix 2 Parameter Cross Reference
54 YASKAWA PL.A1000.02 F7 to A1000 - Product Transition Guide
Display Setting/
Selection
Drive Mode Unit
Monitor Selection
o1-01 6 * o1-01 106 * *See the comments given for parameter F4-01.
User Monitor
Selection After
Power Up
o1-02 1 o1-02 1
o1-02 o1-02
1: Frequency reference 1: Frequency reference
2: Output frequency 3: Output frequency
3: Output current 4: Output current
4: User-selected Monitor
(set by o1-01)
5: User-selected Monitor (set by o1-01)
— 2: Direction
Digital Operator
Display Selection
o1-03 0 o1-03 *
o1-03 o1-03
0: Hz units 0: 0.01 Hz units
1: % units
(100 % = E1-04)
1: 0.01 % units
2 to 39: RPM 2: r/min units
40 to 39999: User display
3: User-set units
o1-10
o1-11
1 to 60000 0 to 3
o1-10: Determines how the units for the frequency reference.
o1-11: Sets the decimal point for the frequency reference display
*Determined by parameter A1-02
Ex. : For a max output frequency of 200.0, set the following:
Setting value :
o1-03=12000
Setting value: o1-03=3
: o1-10=2000
: o1-11=1
1 2 0 0 0
│ └ Max value, excluding decimal point → o1-10= “2000”
└── digits displayed to the right of the decimal → o1-11= 1
Setting Unit for
Frequency
Parameters Related
to V/f
Characteristics
o1-04 0 o1-04 *
o1-04 o1-04
0: Hz units 0: Hz units
1: r/min units 1: r/min units
*Determined by A1-02
LCD Brightness o1-05 3 — — This parameter is not available in A1000.
Parameter Name
F7 A1000 Setting
Parameter Default Parameter Default F7 A1000