SMA STP 5000TL - Manual (Page 39)

All Bluetooth devices in a PV system must have the same NetID. You can use rotary switch C to set
a new NetID in the inverter before commissioning. The setting will be adopted after commissioning.
This can take up to five minutes.
Figure 12: Positions of rotary switch C
Position Explanation
0 Communication via Bluetooth is deactivated.
1 Communication via Bluetooth with a further Bluetooth device
2 to F NetID for communication via Bluetooth with multiple Bluetooth devices
Procedure:
1.
Danger to life due to high voltages
• Ensure that the inverter is disconnected from all voltage sources (see Section 10, page 51
).
2. To configure a new NetID, set the rotary switch
C to the determined NetID using a flat-blade
screwdriver (blade width: 2.5 mm).
7 Commissioning SMA Solar Technology AG
Operating Manual 39 STP5-10TL-20-BE-en-13