HEIDENHAIN iTNC 530 (340 49x-02) - Manual (Page 8)

8
Functions included in 340 49x-01 new since the
predecessor versions 340 422-xx and 340 423-xx
„ A new form-based operating mode, smarT.NC, introduced. These
cycles are described in a separate user's document. In connection
with this the TNC operating panel was enhanced. There are some
new keys available for quicker navigation within smarT.NC (see
“Operating panel” on page 40).
„ The single-processor versions supports pointing devices (mice) via
the USB interface.
„ The tooth feed f
z
and feed per revolution f
u
can now be defined as
alternate feed entries See table “”.
„ New CENTERING cycle (see “CENTERING (Cycle 240)” on page
305)
„ New M function M150 for suppressing limit switch messages (see
“Suppress limit switch message: M150” on page 279)
„ M128 is now also permitted for mid-program startup (see “Mid-
program startup (block scan)” on page 600).
„ The number of available Q parameters was expanded to 2000 (see
“Principle and Overview” on page 532).
„ The number of available label numbers was expanded to 1000. Now
label names can be assigned as well (see “Labeling Subprograms
and Program Section Repeats” on page 516).
„ In the Q parameter functions FN9 to FN12 you can now also assign
label names as jump targets (see “If-Then Decisions with
Q Parameters” on page 540).
„ Selectively machine points from a point table (see “Hiding single
points from the machining process” on page 299).
„ The current time is also shown in the additional status display
window (see “General program information” on page 45).
„ Several columns were added to the tool table (see “Tool table:
Standard tool data” on page 166).
„ The Test Run can now also be stopped and continued within
machining cycles (see “Running a program test” on page 594).