HEIDENHAIN iTNC 530 (340 49x-02) User Manual
Page 361
HEIDENHAIN iTNC 530
361
8.4 Cy
cles f
o
r Milling P
o
c
k
ets, St
uds and Slots
8
Machining operation (0/1/2)
Q215: Define the
machining operation:
0: Roughing and finishing
1: Only roughing
2: Only finishing
Side finishing and floor finishing are only executed if
the finishing allowances (Q368, Q369) have been
defined.
8
Circle diameter
Q223: Diameter of the finished
pocket.
8
Finishing allowance for side
Q368 (incremental
value): Finishing allowance in the working plane.
8
Feed rate for milling
Q207: Traversing speed of the
tool in mm/min while milling.
8
Climb or up-cut
Q351: Type of milling operation with
M03.
+1 = climb milling
–1 = up-cut milling
8
Depth
Q201 (incremental value): Distance between
workpiece surface and pocket floor.
8
Plunging depth
Q202 (incremental value): Infeed per
cut. Enter a value greater than 0.
8
Finishing allowance for floor
Q369 (incremental
value): Finishing allowance in the tool axis.
8
Feed rate for plunging
Q206: Traversing speed of
the tool while moving to depth in mm/min.
8
Infeed for finishing
Q338 (incremental value):
Infeed per cut. Q338=0: Finishing in one infeed.
X
Y
Q207
Q223
X
Z
Q201
Q206
Q202
Q338