HEIDENHAIN iTNC 530 (340 49x-02) - Manual (Page 300)

300 8 Programming: Cycles
8.2 P
o
int
T
a
bles
Selecting a point table in the program
In the Programming and Editing mode of operation, select the
program for which you want to activate the point table:
Press the PGM CALL key to call the function for
selecting the point table.
Press the PUNKTE-TABELLE soft key.
Enter the name of the point table and confirm your entry with the END
key. If the point table is not stored in the same directory as the NC
program, you must enter the complete path.
Example NC block
7 SEL PATTERN “TNC:\DIRKT5\NUST35.PNT“