HEIDENHAIN iTNC 530 (340 49x-02) - Manual (Page 687)

Miscellaneous functions
M Effect Effective at block start End Page
M00 Stop program/Spindle STOP/Coolant OFF „ page 261
M01 Optional program STOP „ page 605
M02 Stop program/Spindle STOP/Coolant OFF/Clear status display
(depending on machine parameter)/Go to block 1 „ page 261
M03
M04
M05 Spindle ON clockwise
Spindle ON counterclockwise
Spindle STOP „
„
„
page 261
M06 Tool change/Stop program run (depending on machine parameter)/Spindle STOP „ page 261
M08
M09 Coolant ON
Coolant OFF „
„
page 261
M13
M14 Spindle ON clockwise/Coolant ON
Spindle ON counterclockwise/Coolant ON „
„ page 261
M30 Same function as M02 „ page 261
M89 Vacant miscellaneous function or
Cycle call, modally effective (depending on machine parameter) „
„
page 295
M90 Only in lag mode: Constant contouring speed at corners „ page 265
M91 Within the positioning block: Coordinates are referenced to machine datum „ page 262
M92 Within the positioning block: Coordinates are referenced to position defined by machine
tool builder, such as tool change position „ page 262
M94 Reduce display of rotary axis to value under 360° „ page 282
M97 Machine small contour steps „ page 267
M98 Machine open contours completely „ page 269
M99 Blockwise cycle call „ page 295
M101
M102 Automatic tool change with replacement tool if maximum tool life has expired
Reset M101 „
„
page 177
M103 Reduce feed rate during plunging to factor F (percentage) „ page 270
M104 Reactivate the datum as last defined „ page 264
M105
M106 Machining with second k
v
factor
Machining with first k
v
factor
„
„ page 654
M107
M108 Suppress error message for replacement tools
Reset M107 „
„
page 176