HEIDENHAIN TNC 320 (340 55x-05) ISO programming - Manual (Page 61)

HEIDENHAIN TNC 320 61
2.4 Stat
us Displa
ys
2.4 Status Displays
"General" status display
The general status display in the lower part of the screen informs you
of the current state of the machine tool. It is displayed automatically in
the following modes of operation:
„ Program Run, Single Block and Program Run, Full Sequence, except
if the screen layout is set to display graphics only, and
„ Positioning with Manual Data Input (MDI).
In the Manual mode and Electronic Handwheel mode the status
display appears in the large window.