Mod functions – HEIDENHAIN TNC 320 (340 55x-05) ISO programming User Manual
Page 31
HEIDENHAIN TNC 320
31
15.1 Selecting MOD Functions ..... 394
Selecting the MOD functions ..... 394
Changing the settings ..... 394
Exiting the MOD functions ..... 394
Overview of MOD functions ..... 395
15.2 Software Numbers ..... 396
15.3 Entering Code Numbers ..... 397
15.4 Setting the Data Interfaces ..... 398
Serial interfaces on the TNC 320 ..... 398
Setting the RS-232 interface ..... 398
Setting the baud rate (baudRate) ..... 398
Set the protocol (protocol) ..... 398
Set the data bits (dataBits) ..... 399
Parity check (parity) ..... 399
Setting the stop bits (stopBits) ..... 399
Setting the handshake (flowControl) ..... 399
Settings for data transfer with the TNCserver PC software ..... 400
Setting the operating mode of the external device (fileSystem) ..... 400
Software for data transfer ..... 401
15.5 Ethernet Interface ..... 403
Connection possibilities ..... 403
Connecting the control to the network ..... 403
15.6 Position Display Types ..... 409
15.7 Unit of Measurement ..... 410