HEIDENHAIN TNC 320 (340 55x-05) ISO programming - Manual (Page 26)

26
11.1 Functions for Multiple Axis Machining ..... 298
11.2 The PLANE Function: Tilting the Working Plane (Software Option 1) ..... 299
Introduction ..... 299
Define the PLANE function ..... 301
Position display ..... 301
Reset the PLANE function ..... 302
Defining the machining plane with space angles: PLANE SPATIAL ..... 303
Defining the machining plane with projection angles: PROJECTED PLANE ..... 305
Defining the machining plane with Euler angles: EULER PLANE ..... 307
Defining the working plane with two vectors: VECTOR PLANE ..... 309
Defining the working plane via three points: PLANE POINTS ..... 311
Defining the machining plane with a single, incremental space angle: PLANE RELATIVE ..... 313
Tilting the working plane through axis angle: PLANE AXIAL (FCL 3 function) ..... 314
Specifying the positioning behavior of the PLANE function ..... 316
11.3 Miscellaneous Functions for Rotary Axes ..... 320
Feed rate in mm/min on rotary axes A, B, C: M116 (software option 1) ..... 320
Shorter-path traverse of rotary axes: M126 ..... 321
Reducing display of a rotary axis to a value less than 360°: M94 ..... 322
Selecting tilting axes: M138 ..... 323
Compensating the machine’s kinematics configuration for ACTUAL/NOMINAL positions at end of block: M144
(software option 2) ..... 324
11 Programming: Multiple Axis Machining ..... 297