HEIDENHAIN TNC 320 (340 55x-05) ISO programming - Manual (Page 373)

HEIDENHAIN TNC 320 373
14.1 Gr
aphics
If there is a mouse attached to your TNC, you can also perform the
functions described above with the mouse.
U In order to rotate the graphic shown in three dimensions: Hold the
right mouse button down and move the mouse. After you release
the right mouse button, the TNC orients the workpiece to the
defined orientation
U In order to shift the graphic shown: Hold the center mouse button
or the wheel button down and move the mouse. The TNC shifts the
workpiece in the corresponding direction. After you release the
center mouse button, the TNC shifts the workpiece to the defined
position
U In order to zoom in on a certain area with the mouse: Draw a
rectangular zoom area while holding the left mouse button down.
After you release the left mouse button, the TNC zooms in on the
defined area of the workpiece
U In order to quickly zoom in and out with the mouse: Rotate the
wheel button forward or backward